16CH SERVO CONTROLLER WITH USB - PIC,8051,AVR ,USB PROGRAMMER,DEVELOPMENT BOARDS - alselectro

Search
Go to content

Main menu:

16CH SERVO CONTROLLER WITH USB

16 CH SERVO CONTROLLER WITH USB

16 CH SERVO CONTROLLER WITH USB

No Stock

Rs 0.00(VAT excl.) Add

16 CHANNEL SERVO CONTROLLER  FOR ARDUINO ROBOT


Up to 16 servo motors can be controlled at the same time, either by using a software on a PC, or UART communication ( TTL serial port) of MCU (51, AVR, ARM, FPGA, PIC, etc.) to send commands to control the steering.
Controlling MCU power supply: 6.5~12 V or 3.5~5.5V.
Servos power supply: DC (depends on the motors, generally 5V DC).
Control channels: 16. (can be controlled at the same time and the accuracy can be adjusted).
Communication Input: USB or UART (TTL or USART). (The Bluetooth or some other wireless module can be used to make the controlling).
Signal Output: PWM (Accuracy 1us).
Servo motor resolution: 1us, 0.09 degrees.
Baud Rate: 9600,19200,28400,57600,115200,128000(recognized automatically).
Servo motors supported: Futaba, Hitec or some other Servos Motor controlled by PWM.
Dimensions: 51mm×43.5mm×1.6mm.
Control mode: USB and UART (TTL) to accept command. (Comes with USB data wire and PC controlling software).
Flash memory: onboard 512K ROM (If every command is used to control the 16 motors at the same time, more than 500 commands can be saved.)

 
Back to content | Back to main menu