SE
SARAVANA
TITLE
NET
Go to content

ARM7 LPC2148 FULL DEVELOPMENT KIT

DEVELOPMENT > 8051 / ARM > ARM7
New USB upload
Rs4,200.00(VAT excl.)
Add

ARM7 LPC2148  FULL DEVELOPMENT KIT














LPC 2148 Specification:

NXP LPC 2148 with 12 MHz Crystal Oscillator (With Boot loader Software)
High Performance 32-bit ARM7 CPU

512 KB Programmable Flash Memory provides minimum of 10,000 erase/write cycles and 10 years of data-retention.
32 KB + 8 KB Data Memory  (SRAM)
Provides 8KB of on-chip RAM accessible to USB by DMA
USB 2.0 Full-speed compliant device controller with 2 KB of endpoint RAM.

In-System Programming/In-Application Programming (ISP/IAP) via on-chip boot loader software.
Single Flash sector or full chip erase in 400 ms and programming of 256 bytes in 1 ms.

Two 10-bit ADCs provide a total of 14 analog inputs, with conversion times as low as 2.44 us per channel.
Single 10-bit DAC provides variable analog output.
Two 32-bit Timers/External event counters.
Four Capture and four Compare channels.
PWM unit with six output pins.

Low power Real-time clock with independent power and dedicated 32 kHz clock input.
Multiple serial interfaces including two UARTs, two Fast I2C (400 kbit/s), SPIā„¢ and SSP  with buffering and variable data length capabilities.
Vectored interrupt controller with configurable priorities and vector addresses.

60 MHz maximum CPU clock available from programmable on-chip Phase-Locked Loop (PLL) with settling time of 100us.
On-chip integrated oscillator operates with external crystal in range of 1 MHz to 25 MHz
Power saving modes include Idle and Power-down.

Individual enable/disable of peripheral functions.
Processor wake-up from Power-down mode via external interrupt.

Single power supply chip with Power-On Reset (POR) and Brown-Out Detection (BOD)
CPU Operating Voltage range of 3.0 V to 3.6 V



Description:

The all New LPC2148 Development Board can be used to evaluate and demonstrate the capabilities of NXP LPC2148 microcontrollers.
All I/O pins are broken out on Male Berg strips to enable easy connection with sensors.

Onboard Mini Bread board is provided  for training and development purposes.
Onboard 2mm pitch Female sockets on bottom side to insert Xbee module ,easy to interface and experiment  them .
All I/O pins and Power pins  (5V & 3V3) are made available at  header pins  to ease the wiring .

The development board can be programed by ISP Programmer or separate JTAG programmer/ debugger.
20 pin FRC male connector is provided to connect JTAG programmer.

In ISP Programming mode, user can select the desired interface (Either USB or RS232) using the onboard jumper selection.
Jumpers are provided to select Automatic or Manual ISP Programming mode.
Onboard peripheral interfaces are buzzer, Analog Temp sensor  (LM35) , Analog CERMET POT,LDR , 16X2 LCD, RS232, USB, Voltage Level Converter and connectors for xbee, SERVO Motor, UART0, UART1, JTAG etc.


TUTORIAL BLOG LINK

VIDEO TUTORIAL BLINK LED


VIDEO TUTORIAL LCD INTERFACING






Back to content