IOT SHIELD ESP8266 FOR ARDUINO - PIC,8051,AVR ,USB PROGRAMMER,DEVELOPMENT BOARDS - alselectro

Search
Go to content

Main menu:

IOT SHIELD ESP8266 FOR ARDUINO

IOT SHIELD ESP8266 FOR ARDUINO

CLOUD ENABLED IOT

Rs 1,200.00(GST excl.) Add

IOT SHIELD ESP8266 FOR ARDUINO


Can be plugged on to Arduino UNO or MEGA (not included in this kit)





The shield is designed On esp8266 by Espressif Systems, pin-compatible with Arduino UNO/Mega2560 DevBorad.

The serial wifi shield has the following features:

1、WiFi module is industrial-grade chips ESP8266, which is ESP-12E with metal shield, strong anti-interference ability;

2, Shield is pin-compatible with Arduino Uno, Mega2560 and other control board. A voltage converter chip is used to deal with 3.3V (Esp8266) and 5V (Arduino);

3, Dual DIP switches is used for serial ports so that this module shield can be used alone as an Arduino Uno expansion board, and also be used as ESP8266 expansion board;

4, Serial data is transported to WiFi device transparently, and vice versa. Arduino program does not need any configuration;

5, WebServer is developed to configure WiFi parameters and serial port parameters;

6, The module shield can be used as an independent ESP8266 development board. for instance, downloading the official AT commands firmware, NodeMCU open source firmware can be used;

7, The module shield also can be used as stand-alone expansion board for Arduino Uno.

Technical Specifications
802.11 b / g / n wireless standards            STA / AP modes support

TCP / IP protocol stack, One socket            Supports standard TCP / UDP Server and Client

Supports serial port baud rate configuration: 1200/2400/4800/9600/19200/38400/57600/74800/115200 bps;
Supports serial data bits: 5/6/7/8 bits;
Supports serial parity: none;
Supports serial stop bits: 1/2 bit;
Pin-compatible with Arduino UNO, Mega;

Arduino Pinout 2/3/4/5/6/7/8/9/10/11/12/13;
ESP8266 GPIO Pinout 0/2/4/5/9/10/12/13/14/15/16 / ADC / EN / * UART TX / UART RX;
KEY button: modes configuration;
Dual-Ports DIP switches: switching Arduino and ESP8266;
WiFi operation current: continuous transmission operation: ≈70mA (200mA MAX), idle mode: <200uA;
Serial WiFi transmission rate: 110-460800bps;

Quick start Guide


TCP-UDP-DEBUGGER APPLICATION


 
Back to content | Back to main menu