SE
SARAVANA
TITLE
NET
Go to content

STEPPER DRIVE 3AMP TOSHIBA TB6560

Micro Stepping
Rs650.00(VAT excl.)
Add
STEPPER DRIVE
STEPPER DRIVE

STEPPER MOTOR DRIVE 3 AMP TOSHIBA TB6560


Description:

Recommended supply voltage DC 10V-24V.
Toshiba TB6560A controller.
High speed opto-couplers.
Low voltage, over heating, and over current protection.
3A Maximum rated output current (3.5A peak).
Designed for 2/4 phase, 4 or 6 wire stepper motors with a maximum load current of 3A.
Adjustable load current protection.
Adjustable decay modes.
Excitation modes: 1/2, 1/8. 1/16 step.
Large passive heat-sink.





The EN, CW, and CLK inputs are opto-isolated.

If you are connecting them directly to a microcontroller then we suggest grounding the EN-, CW-, and CLK- pins with your microcontroller as per the diagram above.

EN (Enable input): Grounding EN+ input will enable the motor drive outputs. Providing a logic high will disable outputs to the motor.

CW (Direction input): Grounding CW+ input will cause the motor to rotate anti-clockwise (counter-clockwise). Providing a logic high will cause the motor to rotate clockwise. The direction of rotation also depends upon the motor coil polarity.

CLK (Step input): Continually pulsing the CLK+ input will cause the motor to step in one direction. Depending on the excitation mode setting (via switches SW3 & 4)  the motor will step once per 1 to 16 pulses of the CLK+ pin.




LINK to TUTORIALS



Back to content