SE
SARAVANA
TITLE
NET
Go to content

ESP32 CAMERA MODULE

OV2640 Camera Module
Rs814.20
Add

ESP32 CAM - OV2640 Camera Module




     







Specifications:
- ESP32  - CPU: Xtensa® Dual-Core 32-bit LX6
- ROM: 448 KBytes
- RAM: 520 Kbytes
- Flash: 4 MB
- Support for OV2640 and OV7670 camera
- Maximum clock: 240MHz
- 802.11 b / g / n wireless standard
- 2.4Ghz Wifi connection (150 Mbps maximum)
- Support for SD card
- Built
- in antenna - Micro USB connector
- Wi-Fi Direct (P2P), P2P Discovery, P2P Group Owner mode and P2P Power Management
- Operating modes: STA / AP / STA + AP
- Bluetooth BLE 4.2
- GPIO ports: 16
- GPIO with PWM, I2C, SPI, etc.
- Operating Voltage: 5 V
- Transfer Rate: 110-460800 bps
- Supports Remote Firmware Upgrade


Included:
01 - ESP32-CAM Module
01 - OV2640 2 MP Camera


The ESP32-CAM doesn’t come with a USB connector, so you need an FTDI programmer to upload code through the U0R and U0T pins (serial pins).




There are three GND pins and two pins for power: either 3.3V or 5V.
GPIO 1 and GPIO 3 are the serial pins. You need these pins to upload code to your board.
Additionally, GPIO 0 also plays an important role, since it determines whether the ESP32 is in flashing mode or not.
When GPIO 0 is connected to GND, the ESP32 is in flashing mode.

The following pins are internally connected to the microSD card reader:
GPIO 14: CLK
GPIO 15: CMD
GPIO 2: Data 0
GPIO 4: Data 1 (also connected to the on-board LED)
GPIO 12: Data 2
GPIO 13: Data 3



Back to content