SE
SARAVANA
TITLE
NET
Go to content

NUCLEO STM32 F446RE

DEVELOPMENT > STM MICRO STM8 / 32 > NUCLEO & DISCOVERY
512 KB Flash 128 KB SRAM
Rs2,400.00(VAT excl.)
Add

NUCLEO STM32 F446RE

512 KB Flash     128 KB SRAM








KEY FEATURES
• Includes one STM32 microcontroller in a 64-pin package
• On-board ST-LINK/V2-1 debugger/programmer:
• Virtual COM port
• Mass storage
• Wide extension capabilities with specialized shields:
• Arduino Uno rev3 connectors on Nucleo-64
• Access to all MCU pins through ST morpho connectors on Nucleo-64
• Direct access to Mbed online resources for most boards
• Supported by IAR, Keil, Arm® Mbed™ online, and GCC-based IDEs (Atollic, AC6, Emprog, Keolabs, Rowley,
Segger, Tasking...)


Microcontroller features

STM32F446RET6 in LQFP64 package          ARM®32-bit Cortex®-M4 CPU with FPU


180 MHz max CPU frequency    VDD from 1.7 V to 3.6 V       512 KB Flash     128 KB SRAM System

4 KB SRAM Backup          Timers General Purpose (10)        Timers Advanced-Control (2)
Timers Basic (2)         SPI (4)       I2S (2)       USART (4)      UART (2)     USB OTG Full Speed and High Speed
CAN (2)       SAI (2)       SPDIF-Rx (1)        HDMI-CEC (1)       Quad SPI (1)      Camera Interface
GPIO (50) with external interrupt capability
12-bit ADC (3) with 16 channels
12-bit DAC with 2 channels

Nucleo features

Two types of extension resources
1) Arduino Uno Revision 3 connectivity
2) STMicroelectronics Morpho extension pin headers for full access to all STM32 I/Os

On-board ST-LINK/V2-1 debugger/programmer with SWD connector
Selection-mode switch to use the kit as a standalone ST-LINK/V2-1
Flexible board power supply
USB VBUS or external source (3.3 V, 5 V, 7 - 12 V)
Power management access point
User LED (LD2)
Two push buttons: USER and RESET
USB re-enumeration capability: three different interfaces supported on USB
Virtual Com port
Mass storage (USB Disk drive) for drag'n'drop programming
Debug port

How to Program STM32 Nucleo Boards

The Nucleo Development Boards is relatively easy to get started and learn since it has an in-built programmer and debugger.
The Board can be programmed with many Development tool chains which are listed below

Keil MDK-ARM
IAR Workbench
GCC based IDE
ARM Mbed (online)

Out of these the Keil MDK is the most used one. It is beginner friendly and on top of that it is free to use


VIDEO TUTORIAL : GETTING STARTED WITH NUCLEO STM BOARDS

Back to content